3
•
Allow to cool before putting on or
taking off parts and before cleaning.
•
This appliance is not intended to be
used by young children or infirm
persons without supervision.
•
This appliance is not intended for
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible
for their safety.
Mains lead
•
The mains lead should reach from
the socket to the base unit without
straining the connections. Reduce
the length of the lead by storing the
excess in the cord storage facility in
the base unit.
•
Do not let the mains lead hang over
the edge of the worktop where a
child could reach it.
•
Do not let the lead run across an
open space e.g. between a low
socket and table.
•
Do not let the lead run across a
cooker or toaster or other hot area
which might damage the cable.
•
Do not place the kettle where the
mains lead could fall into a sink.
•
If the supply cord is damaged it
must be replaced by the
manufacturer or its service agent or
similarly qualified person in order to
avoid a hazard.
Children
•
Children do not understand the
dangers associated with operating
electrical appliances. Never allow
children to use this appliance.
•
Young children should be
supervised to ensure they do not
play with the appliance.
Other safety
considerations
•
Do not operate any appliance with a
damaged cord or plug or after the
appliance malfunctions or has been
damaged in any manner. Ring the
helpline number for advice on
examination and repair.
•
The use of attachments or tools not
recommended or sold by Morphy
Richards may cause fire, electric
shock or injury.
•
Do not tamper with the connector in
any way.
•
Do not use the kettle for any use
other than to boil water.
•
Do not use outdoors.
•
Do not place the kettle on or near a
hot gas or electric burner or in a
heated oven.
•
The kettle must not be on the base
unit when being filled with water.
•
The mains lead of the cordless base
cannot be repaired. If the mains
lead is damaged, the cordless base
should be discarded and replaced.
•
Unplug from the outlet when not in
use.
•
Do not leave unattended whilst in
use.
•
Always keep the top of the cordless
base dry, especially around the
connection area,disconnect
thepower supply before drying.
Allow to dry thoroughly before
reconnection to the power supply.
Treating scalds
•
Run cold water over the affected
area immediately. Do not stop to
remove clothing, get medical help
quickly.
Electrical requirements
Check that the voltage on the rating
plate of your appliance corresponds
with your house electricity supply
which must be 220 - 240 volts AC.
g
43690-92-94MCZ-Q6:9225 47507 MEE pump - Jon 15/1/08 09:47 Page 3
