11
11
For details of other Morphy Richards products, please see our website:
1
Unwind and straighten the supply and power
cords (
‡
and
·
).
2
Fill the water tank with clean tap water (see
page 10).
3
Connect the unit to the mains supply.
The LCD display screen
„
will illuminate for
1-second and be accompanied with a short
beep sound, then the unit will turn off and will
remain in STANDBY mode until re-activated.
The STANDBY ICON is also visible in the
corner of the display screen.
4
Press the POWER STANDBY button to activate
the unit and set the iron temperature control
dial on the iron to the 3-dot setting.
At this time, the pump will fill the boiler with
water. You will hear the pump operating - this
is quite normal. The filling sequence takes
approximately 25 seconds.
The unit will heat and automatically default to
the LOW STEAM level, the STEAM ICON will
flash on the display screen and will remain
permanently on when steam is available for
ironing.
The AUTO STANDBY feature will activate if
the iron is not used for 15 minutes. Press the
POWER STANDBY button or steam trigger to
reactivate the iron.
Steam settings
To increase or decrease the steam setting, press
the STEAM S/- buttons. These
settings include:
NO STEAM
G
,
LOW STEAM LEVEL
H
,
MEDIUM STEAM LEVEL
I
and HIGH STEAM LEVEL
J
.
LOW STEAM LEVEL
MEDIUM STEAM LEVEL
HIGH STEAM LEVEL
The STEAM ICON will flash until the unit reaches
the selected temperature. Once the temperature
has been reached, the STEAM ICON will remain lit.
When navigating though the steam settings, a
SHORT BEEP will be heard for every operation
of the STEAM S/- buttons a further
LONGER BEEP will be heard once the unit has
reached the selected setting.
Note: During ironing, the pump will operate
periodically to ‘top up’ the boiler with water.
This is quite normal and lasts for a few
seconds only.
VERTICAL STEAM
Hold the iron in a
vertical position
between 1cm and 2cm
away from the item
K
.
Press the steam trigger
⁄
, this will create
vertical steam. This
feature is especially
useful for removing
creases from hanging
clothes, curtains, wall
hangings etc.
STEAM FUNCTION
During the steaming process, small amounts of
water may be ejected from the soleplate. This is
normal and can be avoided by using the steam
for short amounts of time and only when the iron
is at the correct temperature (the indicator light
on the iron goes out when ready).
Sudden jolts of the boiler unit can also cause
water droplets on the soleplate; therefore, do
not move the base unit during ironing. We
recommend for the first time ironing that you
iron over an old towel.
2. STEAM IRONING
G
H
I
J
K
NO STEAM
RN42236MUK Rev2_Instruction Book 25/10/2010 11:38 Page 11
