55
FILLING
A
A
11
Make sure that the iron is not
plugged in and then set the
variable steam control
‹
‹
to the
‘0’ position before filling the iron
with water.
22
Open the fill cap and pour water
through the filling hole
›
›
into
the water tank
·
·
, using the
beaker provided. One beaker full
of water fills the tank (400ml)
A
A
.
After filling, replace the fill cap.
In hard water areas, the use of
distilled or demineralised water
is recommended.
Never use battery topping up
fluid or water containing any
substances like starch, or sugar,
or defrosted water from a
refrigerator.
33
Always pour out the remaining
water after use.
W
Waarrnniinngg:: W
Whheenn ffiilllliinngg yyoouurr iirroonn
w
wiitthh ttaapp w
waatteerr,, aallw
waayyss uussee tthhee
bbeeaakkeerr pprroovviiddeedd.. N
Neevveerr ffiillll
ddiirreeccttllyy uunnddeerr tthhee ttaapp..
Temperature
control
B
B
Plug in the iron and switch on.
The ‘power on’ indicator lights
„
„
, situated in the back cover,
will illuminate. Set the
temperature control dial
B
B
to
the temperature required, but
don’t start ironing immediately. If
you wait a few minutes, the iron
will stabilise at the required
setting.
Your Morphy Richards iron is
fitted with an indicator light
‡
‡
which will go on and off while
you are ironing. This is perfectly
normal as it shows that the iron
is maintaining the heat setting
you have chosen.
It is always a good idea to begin
with cool fabrics and work up to
higher settings. An iron heats up
quicker than it cools down so
you’ll save time and electricity.
FEATURES OF YOUR
IRON
Temperature
indicator light
The indicator light under the
control knob shows that the iron
is warming up. When the
required temperature is reached,
the light will go out and will
cycle on-off during operation.
Dry ironing
You can use your iron as a dry
iron only. Make sure the variable
steam control
‹
‹
is set to the ‘0’
symbol.
Any temperature setting may be
used depending on the
garment. The spray feature may
be used provided there is water
in the tank (see ‘Filling’ section).
You do not need to put any
water in the tank when dry
ironing only.
Spray
C
C
Press the spray button
¤
¤
and
aim the spray of water at
stubborn creases. You can do
this whilst dry ironing, providing
there is water in the tank. When
using the water spray, it may be
necessary to push the button a
few times to get the spray pump
primed.
Variable steam
D
D
Fill the iron with water
as described in ‘Filling’,
and insert the plug into
the electrical socket.
The steam output can be varied
from low to high by sliding the
variable steam control
D
D
.
When using the iron at the
bottom of the steam
range, the slider switch
should be adjusted to the
‘lowest setting’.
The steam facility should only
be used on garments which are
suitable for ironing at 2 and 3
dot settings.
A
B
B
C
C
D
D
lower
steam
2 dot
higher
steam
3 dot
40684 rev3 17/6/08 17:03 Page 5