Recalling a preset station
Briefly press
NUMBER
on the remote control relating to the preset memory
position required.
Other DAB functions
Manual tune
Selecting this option brings up the multiplex number and frequency in the
display along with a signal strength meter and is useful in areas of poor
reception. The multiplexes can be scrolled through using the
SKIP/SEARCH
buttons and are listed as follows: 5A
5B
5C
5D
12A
12B
12C
12D
13A
13B
13C
13D
13E
13F.
To check the signal strength for a multiplex press
SELECT
when the
required multiplex number is in the display and the unit will tune to that
multiplex and display the signal strength as a bar moving from left to right.
For correct reception the bar should pass the outline box shown in the
display.
To exit this menu at any stage press
SETUP
.
•
Some Multiplexes will appear to have no signal when checked using
the above method this is normal and indicates that the selected
multiplex is not broadcasting in the area where the unit is being used. A
single multiplex can carry a large number of individual stations
therefore it is not necessary for all multiplexes to be used in all areas of
the country.
Dynamic range control (DRC)
DRC enables the alteration of the dynamic range of the received audio
(dependent on broadcast material). The DRC level of a broadcast is set by
the broadcaster and transmitted with the service.
Changing the DRC value applies relative variance to the transmitted level.
When this option is selected the current DRC value is displayed on the top
line of the display and the available adjustment is displayed as a scroll
selection on the bottom line of the display, use the
SKIP/SEARCH
buttons to
view the available adjustment options.
DRC 0: DRC adjustment is switched off;
DRC1/2: DRC adjustment is set to 1/2 of that sent with the transmitted
service;
DRC 1: Applies the DRC scaling as sent with the transmitted service. This
isthe default setting.
Software version
This option shows the version number of the software installed in the unit.
This option can only be viewed and is for information only, no adjustment
is available.
Factory reset
Press and hold
SETUP
, the reset menu will appear on the LCD asking you
to press
SELECT
to confirm. Press
SELECT
to reset the unit. This will revert
the unit to the initial start-up mode and will do a complete re-scan. Please
note if this mode is invoked then all the favourite and preset information
will be lost.
The radio will contain the following default settings:
•
No stations in service list
•
No presets allocated
•
Service order is alphanumeric order
•
DRC value is 1
•
Display mode is scrolling DLS
8
9208 29103MUK 4 19/5/05 4:27 pm Page 8
