Installation
Install horizontally on the rubber feet at the bottom of the unit.
※ Install the unit in such a way, that adequate space is left free for ventilation. Keep space of at least
10mm around the main body.
※ Be sure to install the unit in such a way that the Power Switch can be operated easily and the Mains
Plug can be pulled out without hindrance, in case of emergency.
※ Protection Class: Class I equipment (EN 60950-1)
※ Before using this product, please provide an appropriate power supply cord set conforming to the
input power ratings and to the relevant standards of the area where you use this product.
※ The power supply cord set shall have following configurations:
Length: < 3 m; Conductors: L / N / PE; Class I type mains plug with reliable connection to the
Protective Earthing Conductor of the Building Installation.
Optional Item MC-AC200A-2.0M does comply with these requirements.
4.
Connections
WARNING
・Only SELV circuits, which have reinforced insulation to their equipment
primary circuit, may be connected to the unit.
(SELV according to EN60950-1)
・For connection to the External Signal Connector, use a shielded cable with
a recommended length of less than 2 m (Optional item: MC-EXC-07)
・Please do not excessive input or overload.
External signal connector (EXT)
Model
HDBB-25S（05） : connector（female） （made by HRS）
HDB-CTH : connector case （made by HRS）
Terminal of the Unit
Connector of the cable
HDBB-25P（05）（male）
（made by HRS）
or its equivalent
or its equivalent
Pin assignment
№
Identification
№
Identification
1 10bit digital input 2
0
（10bit/LSB）
14 CH3 Input ON／OFF signal
2 10bit digital input 2
1
15 CH4 Input ON／OFF signal
3 8/10bit digital input 2
2
16 CH1 Control error signal output
4 8/10bit digital input 2
3
17 CH2 Control error signal output
5 8/10bit digital input 2
4
18 CH3 Control error signal output
6 8/10bit digital input 2
5
19 CH4 Control error signal output
7 8/10bit digital input 2
6
20 CH Select0
8 8/10bit digital input 2
7
21 CH Select1
9 10bit digital input 2
8
22 Input trigger
10 10bit digital input 2
9
（10bit/MSB）
23 NC
11 COMMON （＋）
24 NC
12 CH1 Input ON／OFF signal
25 NC
13 CH2 Input ON／OFF signal
19
A09637B5000101B-001
