Morgan PLUS SIX, Руководство пользователя

Страница: 47 / 73

44
Locate the battery securing clamp (3). Loosen the nut on the clamp sufficiently
to allow the end of the J-shaped rod to be unhooked. With sufficient clearance,
the complete clamping assembly can be disconnected. Carefully lift the clamp
assembly, along with the electrical leads fastened to it and ease the cables
towards the front of the vehicle until sufficient clearance is obtained to safely
remove the battery.
JUMP STARTING
To jump start the Morgan Plus Six, connect the positive jump starting power
supply first to the positive terminal on the battery. Connect the negative terminal
of the jump starting power supply to a good earth on the chassis or battery.
NOTICE Great care must be taken to avoid short-circuits when jump-starting
a vehicle.
WARNING Not connecting jump-starting cables correctly may result in
damage to a vehicle’s electrical system.
TOWING
The Morgan Plus Six must not be towed behind another vehicle. If for any reason
the car needs to be transported using means other than the vehicles engine it
should be done using an appropriate car transporter. If this is not an option then
the car should be towed with the drive wheels (rear) off the ground.
WARNING Towing the Morgan Plus Six with the drive wheels on the
ground will cause damage to the transmission system.
NOTICE: It is always best whenever possible to transport a vehicle using
car transporters rather than towing a vehicle. When moving a vehicle using
car transporters secure the vehicle using wheel chocks and wheel tie down
straps. Do not secure the vehicle using the towing loop, bodywork or
suspension components.
Towing Trailers
The Morgan Plus Six is not designed for use as a towing vehicle for either towing
trailers or other vehicles.
WARNING Do not use a Morgan Plus Six to tow trailers or any
other vehicles.