4
5
CARE & CLEANING
PARTS IDENTIFICATION
1
2
3
4
5
1. Chimney
2. Control Panel
3. Main body
4. Oil Collector
5. Air duct assembly
INSTALLATION KIT INCLUDES:
• Install screws package
• User instructions
• Main unit Back hanger
A
B
C
D
E
F
G
TOUCH CONTROL AND MOTION CONTROL
INSTALLATION
ALWAYS SWITCH OFF AND DISCONNECT FROM POWER SUPPLY!
SURFACES
• Wash with warm soapy water and a soft sponge.
• Never use abrasive detergent, scouring pads, steel wool or solvents on any part of this appliance as this
will damage the finishing.
CHARCOAL FILTERS
(for recirculating model only):
• The charcoal cannot be reused and must be replaced once a year or depending on the frequency of
operation.
• Regular maintenance is mandatory for this appliance to function effectively as clogged filters may restrict
airflow and may cause the motor to overheat.
1.
( A )
is the switch to power on Motion Control. The fan will operate when a hand gesture swipes to the
right about 10cm from
( A )
. Lights and
( D )
LED screen will power on simultaneously.
2.
( B )
is Electric Auto-heat Oil cleaning. Press
( B )
when the unit is in operation. The unit will divert the
oil into the inner housing in 10 minutes. Press
( B )
again to cancel the function.
3.
( C )
is to select the low fan speed. Press
( C )
to lower the speed.
Note:
There are 3 fan speed levels. Min. suction power is Speed 1, Max. suction power is Speed 3.
4.
( D )
is the Power ON/OFF switch for Touch control. Press it to power on the unit. Press it again to power
off.
Note:
The LED screen will display Fan speed or Time for auto-heat cleaning.
5.
( E )
is to select high fan speed. Press
( E )
when higher suction power is required.
Note:
There are 3 fan speed levels. Min. suction power is Speed 1, Max. suction power is Speed 3.
6.
( F )
is the ON/OFF light switch. Press
( F )
to turn on the light. Press it again to turn it off.
7.
( G )
is Power OFF switch for Motion Control. The unit will power off when a hand gesture swipes to the
left about 10cm from the
( G )
.
Note:
This function will not be activated when the unit is on auto-heat cleaning.
OPERATING INSTRUCTIONS
6 Screw pipe
Wall
Main unit Hanger
Screw ST4.2X25-C
Buckle fixing plate
Main unit
Main unit
Chimney
Fixing Screws
50
0
80
0-
90
0
12
80
-1
38
0
180
Extension Pipe
1. Use suitable bolts to mount the appliance on a secure surface.
2. The minimum distance between the supporting surface for cookware on the hob and the lowest part of
the range hood with the cooker hood located above a gas appliance should be at least 65 cm. If the
instructions for installation for the
gas hob specify a greater distance,
this has to be taken into account;
3. Ensure the location of the installation
has permanent openings for
ventilation.
4. Regulations concerning the discharge of
air have to be fulfilled.
5. It is strongly recommended that the
cooker hood be installed right over the
exhaust air from cooking.
6. It is not recommended to install the
pipe outlet in the wind direction, which
can prevent the exhaust air from
flowing backwards.
7. Fasten the exhaust outlet components
securely with screws. To ensure good
ejection of exhaust air, do not bend the
pipe excessively.
