REV 08_2009.02
4
4. Operation
The gas in the refrigerating circuit is in the first time compressed, liquefied and then
evaporated in the ventilated evaporator, situated on the top of the container.
This cycle involves the absorption of heath from the air in the refrigerator compartment
and the reason is cooled. The heat produced is then dissipated to the outside
environment by a condenser unit located on the top of the refrigerator.
5. Control unit
The refrigerator is command from a “digital control unit” and a “main switch pilot light” in
the top panel of the refrigerator.
The “main switch pilot light” is for turning on the power supply.
The green pilot light comes on to indicate that the unit is connected to the main
electricity and to start work.
The green pilot light comes off to indicate that the unit is disconnected and don’t work.
The “digital control unit” is for the regulation of all parameters to provide the correct
working of the refrigerator. Please consult all parameters in the attachment manual of
the “digital control unit”.
This manual is part of the instruction manual and is very important in case of service.
6. Handling
The refrigerator arrive in PET film and packed in cardboard box on a wood pallet.
!! The refrigerator must be transported and handled with care to avoid posing a
hazard to persons or property. Never place a refrigerator with an in-built
refrigerated unit on its side or turn it upside down as this may damage or impair
operation of the refrigerated unit. We can not held liable for any damage or
defects arising directly or indirectly from improper handling of the equipment or
non-compliance with the safeguards illustrated above.
7. Installation procedure
a) Place the refrigerator in the coolest and best ventilated part of the room. Don’t
install the refrigerator in the near of heat and direct sunlight sources.
b) Remove the straps securing the cardboard packing
c) Remove the cardboard. Covering
d) Remove the PET protection film
e)
Clean the refrigerator with mild detergent and then dry it with a soft cloth.
8. Connecting to the main power supply !!
This operation must be carried out by professionally and qualified persons.
The refrigerator are supplied complete with a power supply cable for the connection to
the main power supply. A thermomagnetic circuit breaker (not supplied) must be
installed between the mains power point and the power supply cable of the refrigerator.
