11)
Make sure that all edges are flush and securely apply clamps from side to side, top to bottom,
and front to back. Apply ample pressure to ensure glue is spread evenly through each joint
(some glue squeeze-out can be expected). Visually inspect all seams to make sure they are all
closed tightly, you may need to relocate clamps (or add more clamps) to get a perfect fit.
12)
Wipe away any glue squeeze-out on the outside of the enclosure with a damp rag or paper
towel (excess glue on the inside is fine). Allow to dry according to the glue manufacturer's
recommendations and remove clamps.
13)
Finally, fill any open seams with wood filler or a mixture of sawdust and wood glue. Then
sand all surfaces and seams until smooth. Finish enclosure to your liking. See our web page
for ideas and examples.
