three times.
3. After add successful, the device will wake to
receive the setting command from Z-Wave
TM
Controller about 20 seconds.
Remove
1. Have Z-Wave
TM
Controller entered remove mode.
2. Hold down the central key, then press the top-right
key three times within 1.5 seconds to enter the
remove mode.Node ID has been excluded.
Note:
iZRC
-
P
is removed by pressing panic key
three times.
Reset
Notice: Use this procedure only in the event
that the primary controller is lost or
otherwise inoperable.
1. Hold down the central key, then press the top-right
key four times within 1.5 seconds and do not
release the top-right key in the 4
th
pressed, and the
LED will light ON.
Note:
iZRC
-
P
is reset by pressing panic key four
times within 1.5 seconds and do not release the
top-right key in the 4
th
pressed.
2. After 3 seconds the LED will turn OFF, after that
within 2 seconds, release the keys. If successful,
the LED will light ON one second. Otherwise, the
LED will flash once.
3. IDs are remove and all settings will reset to factory
default.
Association 1. Have Z-Wave
TM
Controller entered association
mode.
2. Hold down the central key, then press the top-right
key three times within 1.5 seconds to enter the
association mode.
Note:
iZRC
-
8
supports 9 groups. Group 1 is for
receiving the report message, like AV controls, battery
status. Group 2 to group 9 are for lighting group
control, the device will send the “Basic Set” command
to these groups. And each group support 4 nodes
maximum.
iZRC
-
2
supports 3 groups. The group 1 is for
receiving the report message. Group 2, 3 are for
lighting group control. Each group supports 4 nodes.
•
Including a node ID allocated by Z-Wave
TM
Controller means
“
Add
” or “
Inclusion
”. Excluding a node ID allocated by Z-
Wave
TM
Controller means “
Remove
” or “
Exclusion
”.
•
Failed or success in including/excluding the node ID can be
viewed from Z-Wave
TM
Controller.
Notice 1:
The device can not work normally in the first time.
Please
activate the battery before the first use.
Notice 2:
Always RESET a Z-Wave
TM
device before trying to add it to a
Z-Wave
TM
network.
Notice 3:
When the device into NWI mode, the NWI mode will timeout
after 30 seconds. You can Hold down the central key, then press the
top-right key three times within 1.5 seconds to abort the NWI mode.
2
www.mordomus.com
Specifications
Power by Li 602025 battery.
Signal (Frequency):
868.40 MHz, 869.85 MHz(EU),
908.40 MHz, 916.00 MHz(US),
922~927 MHz(JP/TW),
921.40 MHz, 919.80 MHz(ANZ),
869.00 MHz(RU),
