Mora MOROT611X, Руководство пользователя

Страница: 28 / 32

EN 28
INSTALLATION
The minimum distance between the supporting
surface for the cooking equipment on the hob
and the lowest part of the range hood must be
not less than 50 cm from electric cookers and 65
cm from gas or mixed cookers.
If the instructions for installation for the gas hob
specify a greater distance, this must be adhered
to.
ELECTRICAL CONNECTION
The mains power supply must correspond to the
rating indicated on the plate situated inside the
hood. If provided with a plug connect the hood
to a socket in compliance with current regulations
and positioned in an accessible area, after installa-
tion. If it not fitted with a plug (direct mains con-
nection) or if the plug is not located in an acces-
sible area, after installation, apply a double pole
switch in accordance with standards which assures
the complete disconnection of the mains under
conditions relating to over-current category III, in
accordance with installation instructions.
Warning! Before re-connecting the hood circuit to
the mains supply and checking the efficient func-
tion, always check that the mains cable is correctly
assembled.
The hood is provided with a spcial power cable;
if the cable is damaged, request a new one from
Technical Service.
MOUNTING
Very heavy product; hood handling and installa-
tion must be carried out by at least two persons.
Before beginning installation:
•
Check that the product purchased is of a suita-
ble size for the chosen installation area.
• Remove the charcoal (*) filter/s if supplied (see
also relative paragraph). This/these is/are to
be mounted only if you want lo use the hood
in the filtering version.
• Check (for transport reasons) that there is no
other supplied material inside the hood (e.g.
packets with screws (*), guarantees (*), etc.),
eventually removing them and keeping them.
• If possible, disconnect and move freestand-
ing or slide-in range from cabinet opening to
provide easier access to rear wall/ceiling. Oth-
erwise put a thick, protective covering over
countertop, cooktop or range to protect from
damage and debris. Select a flat surface for
assembling the unit. Cover that surface with
a protective covering and place all canopy
hood parts and hardware in it.
• In addition check whether near the installation
area of the hood (in the area accessible also
with the hood mounted) an electric socket is
available and it is possible to connect a fumes
discharge device to the outside (only suction
version).
• Carry out all the masonry work necessary (e.g.
installation of an electric socket and/or a hole
for the passage of the discharge tube).
Expansion wall plugs are provided to secure the
hood to most types of walls/ceilings. However, a
qualified technician must verify suitability of the
materials in accordance with the type of wall/ceil-
ing. The wall/ceiling must be strong enough to
take the weight of the hood. Do not tile, grout or
silicone this appliance to the wall. Surface mount-
ing only.