EN
0810MPC000-LBL-P2 Rev A
Introduction
This instructions for use manual contains information intended
to ensure the safe, effective, and compliant use of your product.
This manual is intended for pathologists, biomedical equipment
technicians, and housekeeping staff. Keep and consult this reference
manual during the life of the product.
The following conventions are used in this manual:
▪ A
WARNING
highlights a safety-related issue. ALWAYS comply
with this information to prevent healthcare staff injury.
▪ A
CAUTION
highlights a product reliability issue. ALWAYS comply
with this information to prevent product damage.
▪ A
NOTE
supplements and/or clarifies procedural information.
For additional information, including safety information, in-service
training, or current literature, contact your Mopec sales representative.
Description
The 115V Autopsy Saw uses high-speed oscillating action to quickly
cut through bone without harming soft tissue. Because exposure to
infected tissue is reduced, the saw does not require a blade guard.
The saw may be used for removing the skull cap, making linear cuts,
or taking small bone specimens.
Safety Directives
WARNINGS:
▪ Before using this equipment, or any component compatible with
this equipment, read and understand the instructions for use. Pay
particular attention to safety information. Become familiar with the
equipment before use.
▪ Only healthcare professionals trained and experienced in the use
of this medical device should operate this equipment.
▪ Upon initial receipt and before each use, operate the equipment
and inspect each component for damage. DO NOT use any
equipment if damage is apparent.
▪ DO NOT modify any system component or accessory, including
the power cord and power cord plug.
▪ ALWAYS position the equipment so that the power cord plug may
be easily disconnected from the power supply.
▪ DO NOT use this equipment in areas in which flammable
anesthetics or flammable agents are mixed with air, oxygen or
nitrous oxide.
▪ ALWAYS follow the current local recommendations and/or
regulations governing environmental protection and the risks
associated with recycling or disposing of the equipment at the
end of its useful life.
Definitions
The symbols located on the equipment and/or labeling are defined
in this section or in the
Symbol Definition Chart
. See the
Symbol
Definition Chart
supplied with the equipment.
SYMBOL
DEFINITION
This symbol is intended to alert service personnel
of the presence of voltage that may cause injury or
fatal electric shock. Disconnect the device from the
electrical supply before servicing.
On
Off
Accessories
WARNING:
Use only CMM-approved system components
and accessories, unless otherwise specified.
NOTE:
For a complete list of accessories, contact your Mopec
sales representative.
2
https://www.mopec.com/
