13
• Select "NEXT"
• Note OnScreen instructions and select the "FINISH" button
• Cycle ignition key after the successful routine completion.
PROGRAMMING IGNITION KEYS TO THE WIN
CAUTION: Read all notes and cautions for programming procedures.
NOTE: Have the vehicle PIN readily available before running the routine
1.
Connect a battery charger to the vehicle.
2.
With the wiTECH diagnostic application, perform the following steps:
• Select "WIRELESS CONTROL MODULE (WCM)"
• Select the "MISCELLANEOUS FUNCTIONS" tab
• Highlight "PROGRAMMING IGNITION KEYS OR KEY FOBS"
• Select "NEXT"
• Enter the PIN when prompted.
• Select "NEXT"
• Verify that the PIN number is correct
• Once verified select "NEXT"
• Note OnScreen instructions and select the "FINISH" button
• Cycle ignition key after the successful routine completion.
NOTE: If the original keys do not successfully program to the new WIN after the proper procedures are followed
correctly, programming new keys will be necessary.
NOTE: A maximum of eight keys can be learned by the WIN. Once a key is learned by a WIN, that key has ac
quired the Secret Key for that WIN and cannot be transferred to any other vehicle.
ECU RESET
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
CAUTION: Read all notes and cautions for programming procedures.
1.
Connect a battery charger to the vehicle.
2.
With the wiTECH diagnostic application, perform the following steps:
• Select "WIRELESS CONTROL MODULE (WCM)"
• Select the "MISCELLANEOUS FUNCTIONS" tab
• Highlight "RESET ECU"
• Note OnScreen instructions and select the "NEXT" button
• Select "FINISH"
PEM MODULE PROGRAMMING
NOTE: Perform this procedure on vehicles equipped with "Key N Go" push button ignition.
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
CAUTION: Read all notes and cautions for programming procedures.
1.
Connect a battery charger to the vehicle.
2.
With the wiTECH diagnostic application, perform the following steps:
• Select the "PASSIVE ENTRY MODULE"
• Select the "MISCELLANEOUS FUNCTIONS" tab
• Highlight "PEM REPLACED"
WINDOW CALIBRATION
NOTE: Vehicles equipped with the auto up feature must have the windows calibrated after a battery disconnect.
NOTE: The door must be completely closed when starting this step.
1.
Sit in the driver seat and close the door.
2.
Lower the window part of the way down.
3.
Run the window to the full up position and continue to hold the switch for an additional two seconds.
Dec 30, 2010
K6861232
4280353
