VP2DJF-19A016-EB 4/30/04
Page 2 of 7
A – Mounting Bracket Installation:
1)
Disconnect negative battery cable and isolate.
2)
Remove climate control head, if equipped.
3)
Remove center dome light, if equipped. Using a
flat bladed tool, pry off the lamp lens. Remove
lens and dome light carefully to avoid damage to
the headliner.
4)
Remove two headliner retaining clips.
5)
Using the installation template provided (Item 18)
secure it to the headliner using retaining clips in
referenced locations.
6)
Following the instructions on the template, mark
and cut opening in headliner.
7)
Using hands, separate headliner from plastic
headliner bracket. Remove headliner bracket.
It will not be re-used. Remove the center 1/4"
screw from the existing overhead bracket.
8)
Position foam block (Item 2) to mounting
bracket as shown.
9)
Fit rear end of mounting bracket into roof bow
behind headliner. Use screwdriver to confirm
hole alignment. Lightly tap the bracket
rearward to ensure fit to roof bow.
10)
Install three self drilling screws (Item 3) through
forward most mounting bracket holes, into front
roof bow.
11)
Install rear headliner retaining clip into rear hole,
through bracket.
Trim Out
Headliner Bracket
Mounting Bracket
Foam Block
Roof Bow
Screwdriver
Front
Front
Locate and use the
Paper Template (Item
#18) to carefully mark
and cut the
headliner opening.
