3
2/21/2017
K6862610
www.mopar.com
1.
Position the A/C compressor (4) to the engine (5) and install the
3 bolts loosely. Using the sequence shown; upper front bolt (1),
then lower front bolt (2), then rear bolt (3), tighten the bolts to
the proper torque specification 28 N·m (21 ft. lbs.)
NOTE:
Typical A/C compressor and refrigerant lines shown.
2.
Remove the tape or plugs from the opened fittings on the A/C
suction line (3) and the A/C discharge line (4) and the
compressor ports.
3.
Lubricate new dual plane seals with clean refrigerant oil and
install them onto the suction and the discharge line fittings.
Use only the specified seals as they are made of a special
material for the specific refrigerant in the system. Use only
refrigerant oil of the type recommended for the A/C
compressor in the vehicle.
4.
Connect the A/C suction and discharge lines onto the A/C
compressor (5).
5.
Install the nuts (2) that secure the A/C suction line (3) and
discharge line (4) to the A/C compressor and tighten to the
proper torque specification 20 N·m (15 ft. lbs.)
NOTE: When installing accessory drive belt onto pulleys,
make sure that belt is properly routed and all V-grooves make
proper contact with pulleys.
6.
Position the drive belt (2) over all pulleys except for the water
pump pulley (7).
7.
Rotate the tensioner (8)
clockwise
and slip the belt (2) over the
water pump pulley (7).
8.
Gently release tensioner (8).
