Moomba Outback V 2012, Руководство пользователя

Страница: 46 / 92

46
© 2012 Skier’s Choice, Inc.
The Moomba models are equipped with a
Moomba Oz towing tower. The tower is designed
as a stable tower to enhance wakeboarding.
It is NOT intended to be used to tow skiers,
barefooters, tubes, or multiple wakeboarders.
Such use will void any warranties written or
implied.
Be sure that all bolts are tightly in place before
use.
Be aware of and avoid low overhead objects
such as bridges, power lines, overhanging
trees, etc.
T
O
L
OWER
T
OWER
F
OR
S
TORAGE
:
Remove the two hand knobs from the back edge of the base of the tower leg. The hand knobs will stay connected to the
tower leg. Lower the tower downward into the boat.
The tower must be supported when hand knobs are removed, or the tower can fall into the boat injuring passengers or
damaging the boat.
T
O
R
AISE
T
OWER
:
Lift the tower and tighten the hand knob to secure the tower in the upright position.
The threads in the tower base could be damaged if the bolts are not aligned and threaded correctly.
O
Z
T
OWER
Lift and rock the tower back into place until the rear legs align
with the rear feet. (Some manipulation of the cage may be
required to get the legs to line up with the feet.) Install and
tighten the rear head-knob bolts. Tighten the front leg’s allen
bolts.
The threads in the aluminum foot could be damaged if the
bolts are not aligned and threaded correctly.
The Oz Tower is designed to pull a single (1) wakeboarder,
trick skier, or kneeboarder.
TO LOWER THE V2 TOWER, twist the release handle until the
white dot is facing up. Pull the locking pin out. Repeat on other
side. Guide the tower lower. The tower mechanism does have
mechanical spring assist system to help minimize the effort
required to lower the tower.
TO RAISE THE V2 TOWER, guide the tower into the upright
position. Install the locking pin with the white dot up. Push the
locking pin all the way into the tower and then rotate the handle
so the white dot is facing down. Repeat on other side. The tower
mechanism does have mechanical spring assist system to help
minimize the effort required to raise the tower.
Warning: Do not operate the boat without the locking pins
properly installed
V2 T
OWER
V2 T
OWER