Moog Components Group Prizm Fiber Optic USB 1.1 Link Manual
February 17, 2009
Page 9 of 9
3 Appendix B. Prizm Fiber Optic USB 1.1 Link Installation and
Checkout
3.1 General Prizm Fiber Optic USB 1.1 Link Installation Notes
NOTE: Please read all of this section prior to starting the installation process.
Test Equipment Required:
1.
A USB host and at least one peripheral device.
2.
Fluke
3.
Oscilloscope
4.
Fiber optic power meter (optional)
3.2
Prizm Fiber Optic USB 1.1 Link Installation Checkout Procedure
1.
If installing the USB boards in standard 3U VME racks, obtain a Prizm supplied mounting plate
assembly and slide the cards into available backplane slots. If installing the USB boards in a PC-104
configuration, insert boards into stack as desired. If using a standalone configuration, use the supplied
mounting holes to secure the board in a system.
2.
Supply power and ground to the boards using either a backplane or 16-gauge wire (or equivalent)
(+5VDC 1.5 Amps). Verify that the voltage is correct.
3.
Connect a USB 1.1 compliant Host to the Local Host Board and at least one USB 1.1 compliant USB
peripheral to the Remote Hub Board.
3.3 Prizm Fiber Optic USB 1.1 Link System Installation Checkout
Procedure
1.
Connect a singlemode optical fiber between the Local Host and the Remote Hub board.
2.
Turn the power on to both devices and verify that the +5V and +3.3V power LED's light on both
motherboards and both daughtercards.
3.
Using the USB 1.1 compliant host and peripherals, verify that data can be transferred correctly
between devices. Operation of the peripherals should be completely transparent.
4.
Verify operation of the various LEDs on both boards as described in Section 1.4.3.
