Moog MSD Servo Drive Series, Помощь по устройству, Страница: 17 / 320

3 Initial commissioning
Chapter overview
Pictogram
Navigation
►Project tree ►Drive Settings ►Initial commissioning
Brief description

The initial commissioning for the drive can be carried
out with the help of a wizard. The wizard will take you
through the process step-by-step, ensuring that the
available configuration options are presented in a
clear and manageable manner.

This chapter describes how the initial commissioning
wizard works. This wizard is used to set up the initial
configuration for the MSD Servo Drive and make it
possible to move the connected motor.
Contents
3.1 Initial commissioning wizard 17
3.2 Automatic test 22
3.3 Motor 23
3.4 Encoder 24
3.5 Control 24
MOOG
ID No.: CB40859-001 Date: 02/2018
MSD Servo Drive - Device Help
17
3 Initial commissioning
3.1 Initial commissioning wizard
The wizard guides you through the subject areas that are relevant for the initial
commissioning. Correct setting of the parameters permits controlled movement of
the drive via the manual mode window (for details see Section "Manual mode" on
page
302 ). Further settings must be made to exactly adapt the drive system to an
application.
3.1.1 Hardware requirements

Correct assembly and installation, in line with the intended use, as per the
instructions in the applicable Operation Manual (see
Section
"Applicable
documentation" on page 11).

Power supplies
o
24 V control voltage
o
Mains voltage

Hardware enable
o
Safe stop (
ISDSH
)
o
Enable Power (
ENPO
)
3.1.2 Prompt Initial commissioning
If Moog D
RIVE
A
DMINISTRATOR
is opened without an existing project, a prompt to
undertake initial commissioning appears automatically.