TUNING PROCEDURE, THIRD VERSION
I have never owned a Minimoog with this board, so I am just copying the procedure from the
manual.
The arrangement of the trimpots is as follows: each row pertains to each oscillator, the top is
OSC1, middle is OSC2, bottom is OSC3. From the right, the 1st trimpot is SHIFT (also
known as RANGE), the next is OCTAVE, the next is SCALE, and the fourth is HI END.
Only the SHIFT, OCTAVE, and SCALE trimpots are accessable through the access holes on
the rear cover. If the Minimoog is below serial #10175 and you have the third version board,
there may or may not be new access holes drilled out for OCTAVE.
26) Set the front panel controls as follows:
TUNE=0
GLIDE=0
PITCH WHEEL=CENTER (detent)
MOD WHEEL=OFF
OSCILLATORS
OSCILLATOR MOD=OFF
OSC 3 CONTROL=ON
ALL OSC RANGE SWITCHES=16
ALL OSC WAVEFORMS=RAMP
OSC 2 RANGE=0
OSC 3 RANGE=0
MIXER
ALL OSC MIXER VOLUME=7
NOISE/EXT IN=OFF
FILTER
FILTER MODULATION=OFF
KEYBOARD CONTROL 1=OFF
KEYBOARD CONTROL 2=OFF
CUTOFF FREQUENCY=(+)5
EMPHASIS=0
AMOUNT OF CONTOUR=0
CONTOURS
ATTACK=1M
DECAY=1M
SUSTAIN=10
MAIN OUTPUT VOLUME=10
MAIN OUTPUT=ON
