13
output in Stereo applications. The default configuration is that the Right
Output carries a mix of the Dry signal plus the inverted Wet signal. When
the outputs are panned hard left and right, this creates a rich stereo effect.
In this mode, when both outputs are mixed together and panned to the
center the wet signal is cancelled. Refer to the section entitled “Output
Configuration” for information on other stereo output modes.
FEEDBACK (FB) INSERT
- 1⁄4” TRS jack designed to be used with a standard
insert cable to process the
BBD
feedback signal path separate from the
Dry signal path. This is an unbalanced, line-level output and input. The
BBD output signal appears at the tip of the jack, and the return to the
device is applied to the ring of the jack. Because these are line level signals,
some means of attenuation or amplification may be required if using
devices designed for lower signal levels, such as typical guitar stomp-boxes.
FEEDBACK
- 1⁄4” TRS jack that can be used with a Moog EP-2 expression
pedal, or a 0V to +5V control voltage on a standard TS cable
To change the feedback from full negative to full positive via control
voltage or expression pedal, set the Feedback control to center position.
TIME
- 1⁄4” TRS jack that can be used with a Moog EP-2 expression pedal,
or a 0V to +5V control voltage on a standard TS cable
To change the delay time for a selected
RANGE
from longest to shortest
via control voltage or expression pedal, set the Delay
TIME
control to
center position.
LFO RATE
- 1⁄4” TRS jack that can be used with a Moog EP-2 expression
pedal, or a 0V to +5V control voltage on a standard TS cable
To use an expression pedal to modify the LFO Rate (.05 Hz to 50 Hz) set
the LFO Rate to center position. Rotate the
LFO RATE
knob counterclockwise.
With a 0V control voltage applied to the LFO Rate CV input, the LFO Rate
can be reduced to half of the minimum panel rate. (.025 Hz) Now rotate
the LFO Rate control fully Clockwise. With a +5V control voltage applied
to the LFO Rate CV input, the LFO Rate can be increased to double the
maximum panel rate. (100 Hz)
LFO AMOUNT
- 1⁄4” TRS jack that can be used with a Moog EP-2 expression
pedal, or a 0V to +5V control voltage on a standard TS cable
To modify the
LFO AMOUNT
from minimum to maximum via control voltage
or expression pedal, set the
LFO AMOUNT
control to center position
MIX
- 1⁄4” TRS jack that can be used with a Moog EP-2 expression pedal,
or a 0V to +5V control voltage on a standard TS cable
To change the Mix from Dry to Wet via control voltage or expression pedal
set the MIX control to center position
MIDI IN
- Standard 5-pin
DIN
for receiving MIDI Messages from another MIDI
device such as a MIDI controller or a computer sequencer.
