Moog G396-026, Руководство по эксплуатации

Страница: 53 / 85

Programmable Multi-Axis Servo Drive Power Supply Unit Operation Manual
ID no.: CA97556-001 Date: 03/2015
moog
53
Commissioning
4.2.4 Communication with the Moog D
rive
A
DministrAtor
5
3.
The Moog D
rive
A
DministrAtor
5 user software must be installed on a PC. The PC can be
connected to the servo drive via USB or Ethernet (TCP/IP).
For a detailed description of Moog D
rive
A
DministrAtor
5 refer to the
Moog D
rive
A
DministrAtor
5 Online Help.
ATTENTION!
Communication between the PC and the servo drive may only be established
once the servo drive has completed its initialisation. The display D1/D2 no
longer indicates "88" or "0".
NOTE:
The Power Supply Unit is factory pre-configured and adapted to the mains
connection set. The factory parameter setting may only be changed by trained
specialist personnel. The parameter changes described in the following are
used to adapt the Power Supply Unit to the parameters of the supply system
and to the number and type of Multi-Axis Servo Drives connected to the DC
terminals X11.
NOTE:
The firmware of the Power Supply Unit must be compatible with the
Moog
D
rive
A
DministrAtor
5 version. If communication fails, the compatibility
must be checked.
!
4.2.3 Switching on control voltage (24 VDC)
2.
In order to initialise and parameterise the Power Supply Unit, only the 24 DC control voltage
supply needs first to be connected to X2 or X10. Ensure correct polarity.
After successful switching on you will be able to read two conditions in the 7-segment
display.
D1 D2 Action Reaction Explanation
Switch-on of ext. 24 V
control voltage
Initialisation OK Initialisation time < 5 s
Not ready for start No DC link voltage Device is initialised
Table 4.4 Switch-on status of the Power Supply Unit (after connection of the 24 V control
supply)