If closed, the progress of the current session can be followed by reopening the “Firmware Update Session” window by clicking the button
from the “Tools” toolbar.
Once done, clear the current session from the “Firmware Update Session” window and restart a new session if needed.
7.0.0 Point to Point Connections
Point-to-point connections between a Moog EXO Camera and a Decoder can be configured using the device’s web application.
In the Moog EXO web application, in the
Configuration
section, go to the
Video In
tab. Scroll down all the way to the bottom of the
configuration page. The last 3 sections are named
Point to Point 1, 2
and
3
.
Here’s a quick overview of the settings available for a connection:
•
Enabled: Indicates whether this connection is to be used.
•
Description: Free-form user description of the connection, not used by the device.
•
Encoder: Indicates which video feed is to be sent over the point-to-point connection. Possible values include «Primary H.264
» and «Secondary H.264». These values refer to the encoders configured in previous sections of the same web page.
•
Destination IP: Address where to send the video. This is usually the address of a Decoder. The destination can also be a
multicast group address. DNS names are not yet supported, only IP addresses.
•
Destination Port: Network port where to send the video. This value must match the port value in the Decoder.
Once all the settings have been set, click on
Save
at the bottom of the page to apply them. The Moog EXO Camera then creates or updates
the connection as needed.
8.0.0 Troubleshooting Guide
•
Device does not seem to boot-up
o
Verify that a 24Vac power supply is connected to the device.
o
When a valid power source is detected, the status Pan / Tilt LED, power will light up GREEN.
•
Cannot discover the device or communicate via the network
o
Dynamic discovery of the Moog Camera requires multicast networking to be supported by your network and switch
equipment. (Bonjour protocol)
o
Make sure you have connected the device to your network.
Содержание EXPD7C1-2
Страница 30: ...2 4 0 Configuration Recording...
