Moog Inc., Components Group, Halifax Operations
Focal Technologies Corporation
77 Frazee Avenue
Dartmouth, Nova Scotia, Canada B3B 1Z4
Tel: 902-468-2263 • Fax: 902-468-2249
[email protected] •
www.moogpowerdata.com
Application Note
This document is the property of Focal Technologies Corporation, and may not be neither copied, reproduced or otherwise dealt with nor its
contents communicated to others except in accordance with written instructions received from Focal Technologies Corporation.
700-0290-00 Rev. 1
Page 5 of 6
Model 903 Console showing the location of the “Link Ready” LED.
CARD HANDLING GUIDELINES
•
Use ESD protection as appropriate. Ensure unit is powered down when removing or installing cards, as the
system is not “hot swappable”.
•
Unscrew both captured front panel screws, but leave a few threads on upper screw to prevent “popping out”.
•
Pull on card until backplane connector unmates. Undo the upper screw completely and withdraw the card
slowly, especially if it is an optical card or adjacent to the FMB to avoid snagging fibers.
•
Do not subject fibers to excessive bends, even momentarily.
•
Ensure any re-mated optical connectors are cleaned immediately prior to remating. (Even clean connectors will
accumulate dirt if left uncovered.)
•
Transport cards in ESD safe bags or boxes.
•
Ensure AIB plug-in modules are installed with their alignment dots matching the dots on the AIB motherboard.
