!
!
ELECTRICAL SPECIFICATIONS (OUTDOOR ONLY):
Power 24VAC, Class 2 Only
26 watts at 24 VAC (accessories)
Heater: 25 watts
Blower: .84 watts
Input Connectors (outdoor units):
BNC Connectors - 1 for each camera
Screw-down connectors - 2
NOTE:
This unit is designed for operation in an upright position. In
stalling the Fusionome™ upside down may cause damage
to the internal equipment, and will void the warranty.
CAMERAS VOLTAGE CURRENT POWER
1 24 VAC/VDC 102mA 2.5W
2 24 VAC/VDC 210mA 5W
3 24 VAC/VDC 331mA 7.9W
4 24 VAC/VDC 487mA 10.9W
Use the formula below to select the correct power supply for cameras connected
in parallel (positive to positive, negative to negative):
Total current for a 24 VAC system:
TOTAL CURRENT = (202mA x total number of cameras)
Note: 202mA is camera plus power supply
CABLE AND POWER GUIDELINES (Detailed info on Page 12)
This chart shows the proper current needed for power supplies for Q-View™
cameras. Use Class 2 Power only. Input voltage must be 24 VAC/VDC.
3. Pull the wires from the wall through the rectangular hole in the wall mount
bracket. Attach the wall mount to the wall using appropriate hardware (not included).
4. Make all wiring connections (See next page). Attach the BNC connectors to the
video in.
5. Once all wiring connections are made, place the wires inside the wall mount
bracket and close the access door. Secure with the screw removed earlier.
WALL MOUNTING THE QFD
1. A template is included as a guide for mounting the bracket to a wall. Choose
the desired location for installation and mark the drill holes using the template. Run
approximately 8"of wiring out of the wall.
2. Open the access door on the bottom of the wall mount by loosening the screw
nearest the mounting plate (Figure 1).
Figure 1
Access door
GENERAL INSTRUCTIONS:
Tools Required: .100" Flat Head Screwdriver, Phillips Head Screwdriver
Carefully remove the housing from the packaging material. Check to be sure all parts
are present.
TABLE OF CONTENTS
Cable and Power Guidelines
1, 11
Electrical Specifications
1
General Instructions
1
Wall Mounting
1
Pendant Mounting
2
Wiring
2
Camera Adjustment
2
Camera Focusing
2
Camera Settings
3
Completion of Installation
3
NVT Instructions
4
Exploded View
6
Warranty Information
7
Service and Safeguard Information
8
Troubleshooting
9
Mounting Template
12
PENDANT MOUNTING THE QFD AND QIFD
1. This unit includes a 1 1/2" NPT housing coupling that can be used with a standard
1 1/2" NPT pipe or with brackets designed with 1
½
" male pipe threads, such as
Moog Videolarm's WM20G.
2. Attach the coupling to the bracket or pendant pipe (Figure 2).
NOTE:
Pipe threads should be clean and rust free. Use a sealer (such as Teflon™
tape or silicone sealer) on the threads for outdoor applications.
Be sure the bracket is properly and securely mounted to a supporting
structure capable of rigidly holding the weight of the entire unit.
Figure 2
Add thread seal-
ing tape
