Anchor Jig Assembly
Anchor Jig Kit Parts List
Single Straps
(4)
Cross Strap
(1)
3/4" - 10 Bolts
(4)
3/4" Flat Washers
(4)
3/4" - 10 Hex Nut
(20)
Lock
Washers
(4)
1. Thread two (2)
nuts
onto each of the (4)
bolts
(Figure 1). The end with 6" of
clearance will be the top of the
Anchor Jig
, the end with 1
½
" clearance will be the
bottom.
NOTE:
Because of surface conditions it may be necessary to use leveling nuts. See
step 5 below for information.
NOTE:
The
Flat Washers
,
Lock Washers
, and remaining
Hex Nuts
will be used to
fasten the pole to the
Anchor Jig.
4.
Before using the
Anchor Jig
verify that the center to center dimensions between
the bolts are even (Figure 4). If not, adjust accordingly. Firmly tighten all
Hex Nuts
.
With Leveling Nuts
Without Leveling Nuts
1
1
/
2
"
6"
18"
Figure 1
1 1/2"
2. Place the short end of each
Bolt
into the outside holes of the
Cross Strap.
Place
Hex Nuts
onto each
Bolt
and finger tighten (Figure 2).
3. Turn the
Anchor Jig
over and place
Single Straps
over the
Bolts
(Figure 3). Use
the inside hole of each strap. Place
Hex Nuts
onto each
Bolt
and finger tighten.
Figure 2
Figure 3
7
25
/
32
"
7
25
/
32
"
11"
diameter
Figure 4
5.
If, due to conditions or other requirements, leveling nuts are needed, adjustments
will have to be made to the
Anchor Jig
. Below are diagrams comparing the
Anchor Jig
with and without leveling nuts. Leveling nuts and washers are NOT
provided with the pole,
