- 2 -
PRODUCT INSTRUCTIONS
REVISION DATE: August 26, 2005
81-IN5210 Bullet Resistant Dome
DeputyDome
™
Standard/Pressurized
DDW10CR/PDDW10CR
WALL MOUNT INSTALLATION:
1
. Remove the (2) tamper resistant screws on the top of the housing
with the security tool provided in the installation packet
(Figure 1, next column).
STANDARD INSTALLATION PROCEDURE
ELECTRICAL SPECIFICATIONS
(Camera with hardwire pan/tilt)
Power Source & Power Consumption
(includes: heater, blower and camera)
P/DDW10CR/02 -
115 VAC, 90 vA, 0.8 Amps
P/DDW10CR2/02 -
24 VAC (Class 2), 90 vA, 3.75 Amps
P/DDW10CR3/02 -
220 VAC, 90 vA, 0.45 Amps
Video Outputs -
1 Vpp/75 ohm composite video
CAMERA SPECIFICATIONS
Resolution -
470TVL - NTSC, 460TVL - PAL
Minimum Illumination -
0.2 Lux B&W mode, 3.0 Lux color mode
Zoom Ratio -
18X, 4.1 - 73.8mm optical, 216x digital
Format -
1/4"
White Balance -
Auto
Electronic Shutter -
20 step
NOTE:
The DeputyDome™ is packed in two separate boxes, one for the
housing and one for the pan/tilt and bullet-resistant liner. Installation
should be completed as follows:
1. Run wiring to the chosen location.
2. Detach the housing and mount the wall bracket.
3. Make wiring connections.
4. Complete wiring runs.
5. Install the pan/tilt and make necessary adjustments.
6. Install the bullet-resistant liner.
7. Attach the housing and ome.
These instructions include procedures for installing both the
standard and pressurized versions.
Figure 1
Figure 3
Figure 2
WIRING (See wiring charts, next page)
FOR NON-PRESSURIZED VERSION
5
. Run all electrical wiring through the bracket and out the access
hole.
6
. Attach appropriate connectors to incoming wiring (Figures 5
and 6). The housing has two inputs for power - one for
heaters, and one for camera and blower. See the general
specifications for current draw at the appropriate voltage.
FOR PRESSURIZED VERSION
5A
. Connect incoming power and video wires to the connector
supplied. (Figures 7 and 8 for pin out on connector.)
NOTE:
It is helpful to attach short leads (2.00") to the video
pins and solder these to the video shield on the coax
cable. Use an insertion tool to assist with the
assembly of the connector.
6A
. Connect the 18-pin connector to the housing.
7
. With the mounting bracket securely mounted and all wiring connections
completed, the next step is adjusting the pan/tilt.
Tamper
resistant
screws
Flange nuts
Tamper
resistant
screws
Access plate
2
. Loosen the (4) flange nuts, and turn the housing clockwise to remove
the housing from the wall mount (Figure 2).
3
. The wall mount can now be attached to the wall with appropriate
fastening hardware.
4
. After the wall mount is securely attached to the wall, remove
the (3) 10-32 tamper resistant screws with the provided
security tool (Figure 3) and take off the access plate.
TABLE OF CONTENTS
Standard Installation Procedure
1
Wiring
1
Installing the Pan/Tilt
3
Installing the Housing
4
Reattaching the Dome (Pressurized)
4
Changing Receiver/Driver Settings
5
Control Functions
6
Exploded View
8
Pressurizing
9
Appendix
10
Warranty Information
19
