6
person on how to use the applicator. Children should be supervised
to make sure they do not play with the device.
WARNING!
Do not tighten the screws completely until the product
has been fully assembled. If you do tighten them completely at an
early stage, significant problems could occur during the further
assembly of the product.
Maintenance and care
Turn off the lamp, remove the batteries and allow the light bulb/lamp to cool completely. Only wipe
them with a damp cloth. Clean the lamp without aggressive cleaning agents, cleaning alcohol or other
chemical solutions. This can damage the case or even affect its function. Replace the batteries of the
remote control as soon as the lights no longer respond to its commands. Replace the batteries of the
lamps as soon as the luminosity decreases considerably. The LEDs are permanently installed and
cannot be replaced.
Commissioning
Light
1.
Open the back of the lamp by turning it counterclockwise to insert the batteries (not
included). Insert the batteries with the correct polarity.
2.
Replace the cover and turn it clockwise.
Remote control
1.
Pull the plastic security label from the remote control
2.
The remote control is directly operational
Assembly
1.
Choose a smooth, even surface (e.g. cupboard or shelf wall) and clean it thoroughly. Allow
the surface to dry completely.
2.
Remove the film from one side of the adhesive pad and attach it to the back of the lamp.
3.
Remove the foil on the other side of the adhesive pad and attach the lamp to the cleaned and
dried surface.
Control
1.
Press the center of the light to manually turn it on and off.
2.
By pressing continuously on the center of the light you can choose between the main colors
(white, red, green, blue).
3.
By pressing the "ON" switch on the remote control, the lamp is switched on continuously. Now
the color can be changed by pressing the desired color.
4.
You can choose between the following modes (see figure)
a.
Flashing
b.
Color change with 3 colors ("STROBE")
c.
Color change with 7 colors ("FLASH")
d.
Color change with all colors ("SMOOTH)
5.
The speed of the different modes can be increased with
decreased with
6.
The light is switched off by pressing the "OFF" switch
MANUEL D’UTILISATION
Généralités