Monty e-bike DPIE 3, Руководство пользователя

Страница: 14 / 29

14
The air pressure must be checked regularly
PRESSURE TABLE
Wheel Recommended Maximum
Bar Kpa PSI Bar Kpa PSI
Front 1,0 100 15 1,4 140 20
Rear 2,0 200 30 2,0 200 30
Equivalences (approx.): 1 Bar = 100 Kpa = 14,5 PSI
Wheels removing
To remove the wheel in case of a tire getting flat or any other reason, one shall follow the
following steps:
Front wheel:
Make sure that the contact is out and remove the key. Disconnect the cable connector, in
case that the vehicle was provided with it. Loose the wheel axle nuts counter clockwise
with a fixed key. Remind the situation of the safety washers towards the assembling.
Remove the wheel in a vertical down position.
To assemble the wheel, place the wheel at its correct position. Fit the safety washers
and tie the nuts clockwise. Connect the engine cable and check the brakes to work
properly.
Rear wheels:
To remove the rear wheel, use a tube key suitable to the nut sizes. Loose the nut and
take out the wheel.. Remind the situation of the washers and the wheels. To fit the
wheels, place the washers and the wheels to their original place and order and tie the
nuts
See section: Torque value
10.2 HANDLEBAR AND STEM
The handlebar must be centred to the stem and perpendicular to the frame..
The handlebar is fitted to the stem by a plate with 4 screws. Loose the screws to regulate
the handlebar position. To fix the handlebar position in a right subjection, tight the
screws in alternate cross form.
The handlebar height can not be changed.
HANDLEBAR FOLDING AND ADJUSTMENT
The folding of the DPIE3 handlebar is easy and practical. Please check the explication in
order to get an easy and safety folding. Make sure that no cables are over-stretched or
pinched when moving the different parts