Montigo Proflame 2, Руководство по установке

Страница: 3 / 6

Installation
Page 3 XT0021 -151127.1
A. Disconnect wire from existing module:
1. Remove valve blind and glass door.
Figure 3
Control module with wires
B. Control Module Connection:
1. Connect the Manual ON/OFF switch to X4.
Figure 4
X4 plug on control module
Figure 5
Attach switch bracket to front of fireplace
C. Main ON/OFF Switch Installation:
1. Position the Main/off Switch bracket on the right leg of the
firebox as shown in
Figure 5 and Figure 6
2. Using the two selftapping screws supplied attach the bracket.
See
Figure 6.
3. Feed the switch and the wires through the slot in the bracket as
shown and install the switch to the bracket. See
Figure 7
.
4. Secure the wires to the floor of the fireplace using the supplied
cable tie and cable tie mounts.
5. Attach the "Main ON/OFF" label supplied to the valve bracket.
Figure 6
Attach switch bracket to front of fireplace
Figure 7
Attach switch to bracket.
X4 Control
Module
Connect Manual ON
OFF switch here