Installation
Page 2
XT0016 - 092214
General Information
This blower kit is for installation with the models listed above.
KIT #
Contents
RX200NG
Control Module, Remote Control, Stepper Motor-NG,
Manual Override switch with harness and bracket,
backup battery pack, Proflame 2 operations manual,
hardware and batteries.
RX200LP
Control Module, Remote Control, Stepper Motor-LP,
Manual Override switch with harness and bracket,
backup battery pack, Proflame 2 operations manual,
hardware and batteries.
Before You Begin
Ensure that the power supply has been turned off at the breaker or
fuse before beginning the installation.
Shut off the gas supply at the shut-off valve, and ensure that the main
burner and pilot light have been turned off and the fireplace has been
cooled off for at least two hours before installation.
General Information
This upgrade kit contains the necessary components for field up-
grade of an approved Montigo fireplace from Proflame 2 basic control
system to Full Load with remote.
The installation of this unit must also conform with local codes or, in
the absence of local codes, with the
American
National Fuel Gas
Code, ANSI Z223.1, or the
Canadian
Installation Code, CAN / CGA
B149.
Tool Required
T20 Torx bit
Impact gun / Drill
1/4 " Nut driver bit
WARNING!
This upgrade kit shall be installed by a qualified service
agency in accordance with the manufacturer's instructions
and all applicable codes and requirements of the authority
having jurisdiction. If the information in these instructions
are not followed exactly, a fire, explosion or production of
carbon monoxide may result causing property damage,
personal injury or loss of life. The qualified service agency
is responsible for the proper installation of this kit. The
installation is not proper and complete until the operation
of the converted appliance is checked as specified in the
manufacturer's instructions supplied with this kit.
Note
Upon successful installation of this upgrade kit, the follow-
ing features are available for the user:
1. Thermostatic and smart thermostatic control of the
fireplace
2. Main burner flame modulation (6 levels)
3. Choice of Standing or Intermittent pilot (CPI switch
required / not supplied)
4. Comfort fan speed modulation (Remote Fan Kit
RFK3002R or RFK3004R required)
5. Battery backup for the main burner during power out-
age
Note:
You may remove the front cover (
See Figure 2
), or the
burner assembly to access the control module and wiring. If
removed, please ensure it is re-installed properly and all gas
connections are leak tested.
Remote Control
Control Module
Battery Pack
Manual override
switch with harness
and bracket
Stepper
Motor-NG
or LP
Proflame 2 Operations
Manual
Figure 1
Contents of Proflame 2 Upgrade Kit
Hardware and
batteries
Figure 2
Fireplace front cover
Table of Contents
A. Disconnect Control Module and Harness:
3
B. Stepper Motor Installation:
4
C. Control Module Installation:
5
D. Main ON/OFF Switch Installation:
6
E. Battery Holder Installation:
7
F. Operation with Backup Battery:
7
G. Operation with MAIN Power:
7
