Page 7
C38-VF Gas Fireplace
Part No. XG0317
WARNING:
If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
partment.
C.
Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by hand,
don't try to repair it, call a qualified service technician. Force
or attempt to repair may result in a fire or explosion.
D.
Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system, and
any gas control which has been under water.
A.
This appliance has a pilot which must be lit by hand. When
lighting the pilot, follow these instructions exactly.
B. BeFOre lIgHtINg
smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
What to Do If You Smell gas:
Do not try to light any appliance.
Do not touch any electrical switch; do not use any phone
in your building.
Immediately call your gas supplier from a neighbour's
phone. Follow the gas supplier's instructions.
If you cannot reach your gas supplier, call the Fire De-
To Turn Off Gas To Appliance:
Operating Instructions
3.
Push in gas control knob slightly and turn
clockwise
to "off". Do not force.
4.
Flip up the lower trim.
1.
Turn off remote switch.
2.
Flip down the lower trim.
1.
StOP!
Read the safety information above on this label.
2.
Flip down the lower trims.
3.
Push in gas control knob and turn clockwise
to "oFF."
4.
Wait five (5) minutes to clear out any gas. Smell for gas,
including near the floor. If you then smell gas,
StOP!
Follow
"B" in the safety information above on this label. If you don't
smell gas, go to the next step.
5.
Locate pilot burner
(See illustration at right.)
and follow
steps below.
6.
Turn knob on gas control counterclockwise
to "PI-
LoT."
7.
Push in gas control knob completely and hold. Light with
Piezo Igniter button. Continue to hold the control knob in for
about (1) minute after the pilot is lit. Release the knob and it
will pop back up. Pilot should remain lit. If it goes out repeat
steps 3 through 8.
If knob does not pop up when released. Stop and im-
mediately call your service technician or gas supplier.
If the pilot will not stay lit after several tries, turn the gas
control knob to "oFF" and call your service technician or
gas supplier.
8.
Push in gas control
knob and turn coun-
terclockwise
to
"oN."
9.
Flip up the lower trim.
10.
Turn on remote switch to ignite fire.
Lighting Instructions:
For Your Safety - READ BEFORE LIGHTING:
Gas Control Knob
(Shown in "Pilot" postion.)
NOTE:
Knob cannot be turned from
"PILOT" to "OFF" unless knob is
pushed in slightly. Do not force.
