12
13
1
•
888
•
557
•
3848
Wards.com
CAUTION: Prior to storing or maintaining your steam press, isolate the unit by re-
moving the cord from the electrical outlet and avoid immersing the unit in water.
1. Water may be left in Water Tank reservoir; however, it is recommended that if
the machine will be stored for a long period of time, any leftover water in the unit
should be drained by pressing the Steam Burst Button before the end of use until
the Water Tank is emptied.
2. Wait approximately 30 minutes for press to cool down before storing. Once
cooled, lower the Pressing Plate onto the Ironing Board; pull down the Pressing
Handle completely, then turn the Locking Knob to locked position.
3. Loosely wrap electrical cord and place it in the Cord Storage Compartment lo-
cated at the left of the Water Tank on the base of the Ironing Board.
4. Wipe steamer with a soft cloth if/when necessary.
5. Store in a cool, dry place.
Storage & Maintenance
Cleaning & Care
1. Fill Water Tank using the provided Water Refill Container.
2. Place the Pressing Cushion in the center of the Ironing Board.
3. Place a clean towel over the Pressing Cushion and the Ironing Board.
4. Set the Fabric Temperature Selection control to the highest setting (Linen). When
the Steam Ready Light (yellow) illuminates, gently lower the Pressing Plate onto
the Pressing Cushion.
5. Press the Steam Burst Button 6 to 7 times. Be careful to avoid touching the hot
metal surfaces and avoid leaving hands under Ironing Board or Pressing Plate
when using the Steam Burst Button.
6. Once the Pressing Plate has cooled down, you can clean the surface with a damp
cloth. Do NOT use any abrasives on the Pressing Plate. This Pressing Plate has a
nonstick coating that will assist in cleaning.
7. The Ironing Board Cover is removable and can be rinsed with mild detergent and
warm water.
Troubleshooting
Prior to using or maintaining your steam press, isolate the unit by removing the
cord from the electrical outlet.
Problem
Solution
LED is not on
• Ensure the press power cord is correctly plugged into a
120V power outlet.
• Ensure circuit breaker is operational.
• Try operating the press from another power outlet.
No heat
• Make sure temperature has been selected.
• Pressing Plate has been left in raised position for more
than 10 minutes and Auto Shutoff has engaged.
No steam
• Water may be low, refill Water Tank.
• Temperature setting is too low to activate steam. Select
a higher temperature and wait for Ready Light (yellow)
to illuminate before steaming.
Buttons are not
working properly
• Unplug the unit from the power outlet for 5 minutes then
plug back in.
E1 Warning
• The Pressing Plate and Ironing Board have been held
together for too long. Separate the plate from the board
and either unplug your unit then plug back in or turn the
press off then on again to restart the unit.
E2 Warning
• If the press is left unused for too long, a beep and
warning will appear. After 10 minutes of no use, the
press will automatically shut off.
E3 Warning
• There is a loose wire in the thermostat. Unplug your
press and call Customer Service.
Steam Burst out-
put is weak
• Pressing Plate needs to be cleaned. Refer to “Cleaning
& Care” section of the manual for proper procedure.
