Monte Carlo Fan Company Rockland 4RKR60, Руководство пользователя и инструкция по установке

Страница: 6 / 11

6
© 2019 Monte Carlo Fan Company
4/2019
22
24
19 20 21
23
Install blade onto blade bracket by blade
screws and washers provided. Tighten
screws securely. Repeat this process for
remaining blades.
Caution : Handle it carefully to keep the
fan with light kit from damage or bend.
Install ball end of downrod into mounting
bracket opening. Align (engage) slot on
ball with tab on mounting bracket.
Warning: Failure to align slot on ball with
tab may result in serious injury.
Important : If using the angle mount,
make sure open end of mounting bracket
is installed facing the higher point of the
ceiling and make sure the ceiling angle is
not steeper than 20º. Longer downrod
may be necessary allowing the fan blades
to rotate without obstructions.
For Canadian installation and for USA fan
and light kit combinations over 35 lbs, in
both flush and downrod modes the safety
cable must be installed into the house
structure beams using 1.5” lag screws,
washers and lock washers provided.
Make sure that when the safety cable is
fully extended the lead wires are longer
than the cable and no stress is placed on
the lead wires.
Note
: If Installing The Secondary Support
Safety Cable in the U.S., Do Not Remove
Knockouts In The Outlet Box.
Thread lead wires and safety cable from
motor assembly through downrod.
Helpful hint:
For easy assembling of the
cross pin on the next installation step.
After slip downrod into the motor yoke,
carefully insert a Phillips screwdriver through
the yoke and downrod (
don’t damage the
lead wires ) as a guide and then push the
cross pin and pull the screwdriver in the
meantime as shown in the inset.
Slip downrod into motor housing yoke,
aligning holes and install cross pin and keeper
pin.
Insert cross pin through yoke and downrod
until point appears on the other side, and
insert keeper pin on cross pin.
Pull the downrod up tight against the cross
pin, and then evenly tighten the downrod set
screws on motor housing yoke.
Place Yoke cover on motor assembly.
Warning : Cross pin and keeper pin must be
installed securely, failure to install them will
result in serious injury.
2
3
1
15~20
°
SAFETY CABLE INSTALLATION
Lag screw
Safety cable
Washer
Lock washer
Canopy
Yoke cover
Safety
cable
Canopy bottom
cap
Yoke
Lead wire
Downrod
Cross pin
Keeper pin
Set screw
Tab
Downrod
Slot