© 2013 Monte Carlo Fan Company
6/15/2013
5
Place blade holders onto blades aligning holes
in blade holder with holes in blade. Make sure
that the side of the blade you select is facing
downward. Install 3 screws to back side of
blade as shown. Tighten
screws securely.
Repeat this process 3 more
times until all
blades are assembled.
27
Lift fan to mounting bracket, aligning the “L”
shape holes with the scresws on the mount-
ing bracket. Turn the fan clockwise to lock
in position. Install the screws that were not
installed from earlier step. Tighten securely.
26
Make wire connections to power source using wire nuts
provided. Make sure that no filiments are outside of
the wirenut. After making the wire connections, the
wires should be spread apart with the grounded con-
ductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on the
other side of the outlet box.
25
Hang fan from mounting bracket by
the hands free hook into a closed hole
on the edge of the Canopy.
22
Hands free hook
Take 4 screws from hardware pack and in-
sert 2, one on each side of bracket to
match the L slot screw holes in canopy.
Keep 2 screws for later use. Remove the
all thread studs from the lower part of the
mounting bracket.
21
Replace the 3 screws removed and
tighten securely. Check motor for
shipping stabilizers and remove if
present.
20
Place canopy over fan body align-
ing holes.
19
Connect black and blue wire from fan to Black or (Hot)
wire from house. Connect White wire from Fan to White
(Neutral) wire from house. Connect Ground leads from
mounting bracket and downrod to Ground lead from
house.
Refer to Safety Tips section of manual.
24
House
Fan
Blue
Black
White
Green
Black
White
Ground
For Canadian installation and for USA fan and light
kit combinations over 35 lbs, in both flush and
downrod modes the safety cable must be installed
into the house structure beams using 3” lag
screws, washers and lock washers provided. Make
sure that when the safety cable is fully extended
the lead wires are longer than the cable and no
stress is placed on the lead wires.
Note
:If Installing The Secondary Support Safety
Cable in the U.S., Do Not Remove Knockouts In
The Outlet Box.
23
Safety cable installation
Safety Cable
Lag Screw
safety
cable
3” lag
screw
lock
washer
washer
