Monte Carlo Fan Company 8TNR56XXD Series, Руководство пользователя и инструкция по установке

Страница: 5 / 10

5
© 2013 Monte Carlo Fan Company
11/20/2013
13 14 15
16 17 18
Partially loosen 2 of the set screws on
mounting bracket corresponding to the
slotted holes on the canopy upper ring.
Remove the other 2 set screws. Save
screws.
Raise canopy to mounting bracket,
aligning loosened screws in mounting
bracket with slotted holes in canopy.
Twist canopy to lock. Reinstall screws
that were previously removed and then
tighten all screw securely.
Flip the blade assembly over and install
blade supporting ring onto the blades
with screws provided.
Note
: Make sure the side with a label
“This side up” is installed upward.
Lift blade assembly up. Aligning the holes
on the coupler and the screw holes on
motor and then install it onto motor using
the screws provided. Tighten screws
securely.
Loosen 2 and remove 1 preassembled
screw from the plate on motor. Save
screw for later use.
Attach light pan onto the plate on motor,
aligning the keyhole slots on the light
plate with the preassembled screws on
the plate. Twist clockwise till lock.
Reinstall the screws which were just
removed. Tighten all screws securely.
Loosen 2 and remove 1 preassembled
screw from the light pan. Save screw for
later use.
Install blades on flywheel with set screws
provided.
Note
: Make sure the side with a label
“This side for blade installation” is
installed upward.
Note:
Put blades on carpet to avoid
blade damage from scratch
Flywheel
Blade
This side for
blade installation
This side up
UP
Blade supporting ring