4
© 2013 Monte Carlo Fan Company
11/20/2013
7
8
9
10
11
12
Partially loosen set screws for the spring
clips
Place upper glass on top of fan. Adjust the
spring clips to hold the glass in place.
Tighten all set screws securely.
Install 4 x 25 watt candelabra base bulbs
(25W Max), Bulbs included
Install ball end of downrod into mounting
bracket opening. Align (engage) slot on
ball with tab on mounting bracket.
Warning:
Failure to align slot on ball with
tab may result in serious injury.
For Canadian installation and for USA fan
and light kit combinations over 35 lbs, in
both flush and downrod mode the safety
cable must be installed into the house
structure beams using 3” lag screws,
washers and lock washers provided.
Make sure that when the safety cable is
fully extended the lead wires are longer
than the cable and no stress is placed on
the lead wires.
Note
: If Installing The Secondary Support
Safety Cable in the U.S., Do Not Remove
Knockouts In The Outlet Box.
Make wiring connections using wire
connectors provided as indicated above.
Connect Black wire from fan to Black
(Hot) wire from house. Connect White
wire from Fan to White (Neutral) wire from
house. Connect all green grounded wires
to Grounded wire from House. Make sure
that no filaments are outside of the wire
connectors.
SAFETY CABLE INSTALLATION
Lag screw
Safety cable
Washer
Lock washer
120V 25W Bulb
Spring clip
Power supply
Black
white
G
rounding/G
reen
Black
W
all switch
Tab
Slot
Upper
glass
