Tighen keeper nut onto threaded
pipe from the light kit.
Lift canopy to ceiling aligning the key
hole slots with the screws on the bottom
of the mounting bracket. Rotate the
canopy counter clockwise to lock in place.
Tighten the screws to secure the canopy.
See insert for key hole shape.
Hang assembled fan from the mounting bracket
installed to ceiling in previous steps. Make sure the
fan is hanging straight. Rotate fan until the tab on
the Mounting bracket engages the slot on the
Downrod Ball. This must be done to prevent the fan
body from rotating when the blades are in motion.
Install keeper nut over lead wires.
8
12
17
18
Make wire connections to power source using wire
nuts provided. Make sure that no filiments are out-
side of the wirenut. After making the wire connec-
tions, the wires should be spread apart with the
grounded conductor and the equipment-grounding
conductor on one side of the outlet box and
ungrounded conductor on the other side of the outlet
box.
11
Check the motor for plastic shipping sta-
bilizer tabs and remove them if they are
present.
7
Remove the 3 screws in round holes.
Remove cap by twisting and pulling
down. Save screws.
Install switch housing to light kit by
turning clockwise to tighten.
16
15
Attach blade brackets to blades
using the blade bracket screws
and washers provided.
13
The screws, washers, and motor
pads are pre-installed to the blade
holders. Attach blade assembly to
motor and tighten screws securely.
14
Connect black and blue wire from fan to
Black or (Hot) wire from house. Connect
White wire from Fan to White (Neutral)
wire from house. Connect Ground leads
from mounting bracket and downrod to
Ground lead from house. Refer to
Safety Tips section of manual.
10
House
Fan
Blue
Black
White
Green
Black
White
Ground
For Canadian installation and for USA fan and
light kit combinations over 35 lbs, in both flush
and downrod mode the safety cable must be
installed into the house structure beams using
the 3” lag screws,washers, and lock washers.
provided. Make sure that when the safety cable
is fully extended the leadwires are longer than
the cable and no stress is placed on the lead-
wires.
9
Safety cable installation
Safety Cable
Lag Screw
safety
cable
3” lag
screw
lock
washer
washer
