Monte Carlo Fan Company 5WF42 Series, Руководство пользователя и инструкция по установке

Страница: 3 / 6

© 2011 Monte Carlo Fan Company
5/10/2012
3
Before you begin installing the fan, Switch power off
at Service panel and lock service disconnecting
means to prevent power from being switched on
accidentally. When the service disconnecting means
cannot be locked, securely fasten a prominent warn-
ing device, such as a tag, to the service panel.
Before installing this fan make sure the outlet box is
properly installed to the house structure. To reduce
the risk of fire, electric shock, or personal injury,
mount to outlet box or supporting system acceptable
for fan support. (Mounting must support at least 35
lbs.)
Use metal outlet box suitable for fan support (must
support 35 lbs). Before attaching fan to outlet box,
ensure the outlet box is securley fastened by at
least two points to a structural ceiling member ( a
loose box will cause the fan to wabble).
Use only
the screws provided with the outlet box.
Loosen set screws with locking nuts and
remove keeper from pin and then pin from
yoke for downrod (see inset).
Install downrod with canopy and yoke covers
into yoke. Align hole in downrod and yoke,
push pin through and replace keeper. Tighten
set screws and locking nuts (see inset).
Install downrod to canopy and then install yoke
cover to downrod. Thread wires and safety
cable through downrod
3
2 1
5
6 4
Hang assembled fan from the mounting bracket
installed to ceiling in previous steps. Make sure the
fan is hanging straight. Rotate fan until the tab on
the Mounting bracket engages the slot on the
Downrod Ball. This must be done to prevent the fan
body from rotating when the blades are in motion.
8
Check the motor for plastic shipping sta-
bilizer tabs and remove them if they are
present.
7
For Canadian installation and for USA fan and light
kit combinations over 35 lbs, in both flush and
downrod modes the safety cable must be installed
into the house structure beams using 3” lag
screws, washers and lock washers provided. Make
sure that when the safety cable is fully extended
the lead wires are longer than the cable and no
stress is placed on the lead wires.
Note :If Installing The Secondary Support Safety
Cable in the U.S., Do Not Remove Knockouts In
The Outlet Box.
9
Safety cable installation
Safety Cable
Lag Screw
safety
cable
3” lag
screw
lock
washer
washer