Install 3 x 40 watt candelabra bulbs.
Bulbs included.
WARNING: Over lamping the fan will
result in the fan lights shutting down
until the proper wattage of bulbs are
installed. Reset the lights by turning off
the wall switch, breaker,or by remote.
Replace bulbs with the correct wattage
bulbs, turn the power on.
40
Install ornate lower cover and glass
onto light kit.
41
Install center plug by turning in
direction of arrow till tight.
42
Install blade and blade holder
assembly to fan motor using the pre-
installed screws,washers and motor
pads. Repeat this process 4 more
times until all blades are installed to
the fan.
31
Loosen 2 screws and remove 1
screw.
33
Install center plug by turning in
direction of arrow.
35
Place over the 2 screws and twist in
direction of arrow to hold in place.
Replace screw removed and tighen
all 3 screws securely.
34
Loosen 2 screws with key slots and
remove 1 screw without key slot.
Place upper cover light kit over 2
screws and twist in direction of arrow
to hold in place. Replace screw
removed and tighten all 3 securely.
36
Plug white wire from fan to white
wire from light kit. Then plug black
wire from fan to black wire from light
kit.
38
Loosen
2 screws and remove 1 sc
r
ew
from light pan. Save screw for later
use.
37
Attach light fixture by aligning keyhole
slots on light fixture with screws on light
pan and twist clockwise till lock. Re-install
the screw removed in step 37. Tighten all
screws secu
r
ely.
39
If not using light kit go to step 33.
If using light kit go to step 36.
32
At this point
you need to
decide if you
are using the
light kit or not.
