Raise fan with downrod assembled to
the ceiling bracket and hang fan
assembly. Be sure to rotate the
downrod ball so that the notch in the
bracket engages the slot in the ball.
Install outer upper glass to fan body.
11
17
Install 4 x 25 watt candelabra base
bulbs.
10
Install downrod into yoke. Align hole
in downrod with hole in yoke and
install cross pin. Install keeper into
cross pin.
8
Tighten 2 downrod set screws and
lock nuts.
9
Set dip switches on the Remote Transmitter and Remote
Receiver to the same settings. This must be done so the
units will communcate properly. If you have other fans you
can set to control from one transmitter by setting both
receivers the same as the transmitter. If you have more
than one fan with remote. You can set the dip switches to
different positiosns to have seperate control.
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
16
Fan and light kit combinations over 35 lbs,
in both flush and downrod mode the safety
cable must be installed into the house struc-
ture beams using the 3” lag screws,washers,
and lock washers. provided. Make sure that
when the safety cable is fully extended the
lead wires are longer than the cable and no
stress is placed on the lead wires.
18
Safety cable installation
Safety Cable
Lag Screw
safety
cable
3” lag
screw
lock
washer
washer
Install inner upper glass to fan body.
12
Install canopy onto downrod.
13
Install half ball on downrod and slide
pin into hole in downrod. Then raise
half ball so that pin fits in notches in
half ball.
14
Tighen set screw in half ball.
15
Thread lead wires and safety cable
through downrod as shown.
7
Содержание 5SWR54XXD Series
Страница 7: ...6 21 06 REV 0 New made from 5GMR manual ...
