background image

Carefully lift fan assembly onto mounting

bracket. Rotate fan so that the notch on the

ball engages the ridge in the mounting bracket.

This will allow hands-free wiring. 

Place shim on blade. Place blade onto blade

holder. 

8

14

7

Install 3 screws and washers per blade and

tighten securely.  Repeat for all 5  blades

15

Check the motor for plastic shipping stabilizer

tabs, and remove them if they are present.

Attach blade assembly to motor using the

motor screws and washers provided. Tighten

screws securely.

16

Make wire connections to power source using

wire nuts provided.  Make sure that no filiments

are outside of the wirenut. After making the

wire connections, the wires should be spread

apart with the grounded conductor and the

equipment-grounding conductor on one side of

the outlet box and ungrounded conductor on

the other side of the outlet box.

10

For pullchain controls, follow diagram above.

Make sure that all exposed wiring is secured

inside wire nuts. Note: Wires from house may

vary in color and may not include ground wire.

After wiring is conplete, gently push wires into

junction box with wire nuts pointing upward.

Refer to point 3 of safety tips.

11

House

Fan

Black

White

Green

Black

White

Green(downrod)

Green(Bracket)

Blue

For control of fan and optional light from wall

location, follow diagram above. NOTE: A profes-

sional electrician is recommended for this type

of installation.

12

For Canadian installation and for USA fan and

light kit combinations over 35 lbs, in both flush

and downrod mode the safety cable must be

installed into the house structure beams using

the 3” lag screws provided.  Make sure that

when the safety cable is fully extended the

leadwires are longer than the cable and no

stress is placed on the leadwires.

9

Safety cable installation

Safety Cable

Lag Screw

After installation of all blades you must replace

the rubber grommet to ensure no water leak-

age through to switch housing.

17

Raise the canopy up and align the two holes in

the canopy with the two holes in the hanger

bracket. Secure with two  screws provided.

13

Tighten both yoke set screws to further secure

downrod. 

Li

gh

Sw

it

ch

Fa

Sw

it

ch

Wall

Control

Install switch cap into switch plate

housing, align the 3 holes and install

3 screws and tighten securely.

18

3” lag screw

safety cable

flat washer

lock washer

Отзывы: