© 2013 Monte Carlo Fan Company
11/1/2013
5
Lift fan to mounting bracket, aligning the “L”
shape holes on the canopy with the screws
on the mounting bracket. Turn the fan
clockwise to lock in position. Re-install the
screws removed in the previous step and
tighten securely.
27
Remove the all thread studs from the
lower part of the mounting bracket.Hang
fan from mounting bracket by the
hands free hook into a closed hole on
the edge of the Canopy. Note: For
Canadian mounting refer to Step #8.
23
Hands free hook
Take 4 screws from hardware pack and in-
sert 2 one on each side of bracket to
match the L slot screw holes in canopy.
Keep 2 screws for later use.
24
Make wire connections to power source using wire nuts
provided. Make sure that no filiments are outside of
the wirenut. After making the wire connections, the
wires should be spread apart with the grounded con-
ductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on the
other side of the outlet box.
26
Connect black and blue wire from fan to Black or (Hot)
wire from house. Connect White wire from Fan to White
(Neutral) wire from house. Connect Ground leads from
mounting bracket and downrod to Ground lead from
house.
Refer to Safety Tips section of manual.
25
House
Fan
Blue
Black
White
Green
Black
White
Ground
Place canopy over fan body align-
ing holes.
21
Replace the 3 screws removed and
tighten securely. Check motor for
shipping stabilizers and remove if
present.
22
Remove side covers from canopy ex-
posing 4 holes. 2 closed holes and 2
open “L” shape holes.
19
Pass leadwires and safety cable
through the canopy.
20
