5
11
12
13
14
15
16
© 2021 Monte Carlo Fan Collections
4/2021
Make wiring connections using wire connectors provided as indicated above.
Brown wire from fan to Brown wire from receiver marked Motor U.
Gray wire from fan to Gray wire from receiver marked Motor V.
Orange wire from fan to Orange wire from receiver marked Motor W.
White wire from fan marked “For light” to White wire from receiver marked “For light”.
Blue wire from fan marked “For light” to Blue wire from receiver marked “For light”.
White (Neutral) wire from house to White wire from remote marked AC IN N.
Black (Live) wire from house to Black wire from remote marked AC IN L.
Connect all green grounded wires to Grounded wire from House.
Make sure that no filaments are outside of the wire connectors.
Insert the remote receiver into mounting bracket.
After making the wire connections, the wires should be spread apart with the grounded conductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on the other side of the outlet box. The splices after being made should be turned upward and
pushed carefully up into the outlet box.
Place the wi-fi antenna outside canopy and stick/fix it onto ceiling.
Caution
: The installation has to be complete before operate the fan. Receiver has to be used on the fan and cannot be bypassed.
Partially loosen one and remove one
preassembled step screw from mounting
bracket (Do not remove the other set
screws). Save the screw.
Lift canopy up, aligning its keyhole slot
with the preassembled step screw on
mounting bracket and twist clockwise to
lock in place. Reinstall the other step
screw and tighten the screws securely.
Attach canopy bottom cap onto canopy
by aligning its holes with the step screws
on mounting bracket and fix it with the
magnet embraced.
Install the blade assembly to motor using
the preinstalled screws. Tighten screws
securely. Repeat this process for
remaining blade assemblies.
Connect the light lead wires from fan to
LED light fixture with a quick connector
as shown in the illustration.
Note
: Be sure quick connector clasped
together completely.
Install the LED light fixture onto the hub
on the fan.
Place light lead wires in the hub and
attach LED light fixture onto the hub by
locating ridges in the LED light fixture
with the grooves on the hub and twist
clockwise until tight
Caution
: Make sure the lead wires are
placed in the hub and keep them from
damage.
Install blade bracket with blade by using
blade set screws and fiber washers
provided. Tighten screws securely.
Repeat this process for remaining blades.
Blade
Blade bracket
Fiber washer
LED light
fixture
HUb
Canopy bottom
cap
Blade screw
Step screw
Step screw