© 2013 Monte Carlo Fan Company
6/25/2013
5
Place blade holders onto blades aligning holes
in blade holder with holes in blade. Make sure
that the side of the blade you select is facing
downward. Install 3 screws and fiber washers
to back side of blade as shown. Tighten
screws securely. Repeat this process 4 more
times until all blades are assembled.
Install blades to motor using the 10 motor
screws provided. Tighten screws securely.
26
27
Lift fan to mounting bracket, aligning the “L”
shape holes with the screws on the mounting
bracket. Turn the fan clockwise to lock in
position. Install the other 2 screws included
in hardware bag and tighten all 4 securely.
25
Replace the 3 screws removed and
tighten securely. Check motor for
shipping stabilizers and remove if
present.
20
Place canopy over fan body align-
ing holes.
19
Remove the all thread studs from the
lower part of the mounting bracket. Hang
fan from mounting bracket by the
hands free hook into a closed hole on
the edge of the Canopy. Note: For
Canadian mounting refer to Step #8.
21
Hands free hook
Take 4 screws from hardware pack
and insert 2 one on each side of
bracket to match the L slot screw
holes in canopy. Keep 2 screws for
later use.
22
Make wire connections to power source using wire nuts
provided. Make sure that no filiments are outside of
the wirenut. After making the wire connections, the
wires should be spread apart with the grounded con-
ductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on the
other side of the outlet box.
24
Connect black and blue wire from fan to Black or (Hot)
wire from house. Connect White wire from Fan to White
(Neutral) wire from house. Connect Ground leads from
mounting bracket and downrod to Ground lead from
house.
Refer to Safety Tips section of manual.
23
House
Fan
Blue
Black
White
Green
Black
White
Ground
