Insert downrod into yoke on top of
the Fan Body. Align the hole in the
Downrod with the hole in the Yoke.
Insert the Pin through the Yoke and
Downrod until the point appears on
the other side.
Install the Keeper Pin
7
8
Remove and keep the 4 screws and
fiber washers pre-attached. Install
the upper glass with screws and fiber
washers securely.
12
Place blade holders onto blades align-
ing holes in blade holder with holes in
blade. Make sure the side of the
blade you select is facing downward.
Install 3 screws and washers to back
side of blade as shown. Tighten
screws securely.Repeat this process 4
more times.
10
Install 4 x 15 watt candelabra
base bulbs included.
13
Remove 2 cardboards pre-installed
to the fan body. Rotate the center
flywheel so that the hole in flywheel
is facing opening of the upper light
kit plate. Insert the blade/blade arm
assembly into the flywheel hole and
tighten the screws securely. Repeat
4 more times.
11
Tighten the 2 set screws on yoke
once the downrod is installed in
place.
9
For Canadian installation in both flush and downrod
mode the safety cable must be installed into the
house structure beams using the 3” lag screws pro-
vided. Make sure that when the safety cable is
fully extended the leadwires are longer than the
cable and no stress is placed on the leadwires.
15
Safety Cable
Lag Screw
Lag Screw
Washer
Lock Washer
Safety Cable
Set dip switches on the Remote Transmitter and Remote
Receiver to the same settings. This must be done so the
units will communcate properly. If you have other fans you
can set to control from one transmitter by setting both
receivers the same as the transmitter. If you have more than
one fan with remote. You can set the dip switches to different
positiosns to have seperate control.
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
16
Ready for wiring
18
Install remote receiver into mounting
bracket.
17
Safety cable installation
Hang assembled fan from the mounting bracket
installed to ceiling in previous step. Make sure the
fan is hanging straight. Rotate fan until the tab on
the Mounting bracket engages the slot on the
Downrod Ball. This must be done to prevent the fan
body from rotating when the blades are in motion.
14
