Monte Carlo Fan Company 5CU52XX Series, Инструкция по эксплуатации

Страница: 4 / 6

20
Install blade bracket with blade by
3 blade screws provided. Tighten
securely. Repeat this process for
remaining blades.
Note : Make sure the side with a label
“This side up” is installed upward.
22
21
L o o s e n 2 a n d r e m o v e 1
preassembled screws from the
plate on motor. Save screw for
later use.
Check motor for shipping stabilizers
and remove if present. Install the blade
assembly to motor using the screws
pre-installed. Tighten screws securely.
Repeat this process for remaining blade
assemblies.
23
Place switch housing over wire harness
from motor.
Attached switch housing
on to the plate on motor, aligning the
keyhole slots with the preassembled
screws on the plate. Twist clockwise till
lock. Install the screw removed in step
22. Tighten all screws securely.
24
Connect plug from fan to plug
from switch housing. Make sure
the plugs are hooked together.
26
25
28
27
Remove 3 preassembled screws
from switch housing cover. Save
screws for later use.
Attach capacitor onto switch
housing by preadhered double-
sided foam tap as shown.
Install switch housing cover with
the screws removed in step 26.
Attach switch housing cover onto
switch housing by aligning the long
slot on switch housing cover with
the reverse switch preassembled on
switch housing as shown.
Hook
19
Place blade bracket onto the
front side of blade by aligning
t h e 3 h o l e s o n b l a d e a s
shown.
Shipping
stabilizer