Carefully lift fan assembly onto mounting brack-
et. Rotate fan so that the notch on the ball
engages the ridge in the mounting bracket. This
will allow hands-free wiring.
10
7
Check the motor for shipping stabilizer
and remove if present. Attach blade
assembly to motor using the motor
screws and washers provided. Tighten
screws securely.
17
Remove 1 screw and loosen 2
screws.
18
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on
the other side of the outlet box.
12
For pullchain controls, follow diagram above.
Make sure that all exposed wiring is secured
inside wire nuts. Note: Wires from house may
vary in color and may not include ground wire.
After wiring is conplete, gently push wires into
junction box with wire nuts pointing upward.
Refer to point 3 of safety tips.
13
For control of fan and optional light from wall
location, follow diagram above. NOTE: A profes-
sional electrician is recommended for this type
of installation.
14
Raise the canopy up and align the two holes in
the canopy with the two holes in the hanger
bracket. Twist into place. Secure with two
screws provided.
15
Li
gh
t
Sw
it
ch
Fa
n
Sw
it
ch
Wall
Control
Attach blade brackets to blades using
the blade bracket screws and wash-
ers provided. The blades will have a
label showing this side up on each
blade.
16
Tighen set screws and nuts to secure
downrod in yoke.
8
Insert downrod into yoke on top of
fan body. Align the hole in the down-
rod with hole in the yoke. Insert pin
through the yoke and downrod until
the point appears on the other side.
Install the keeper.
Check the fan motor for shipping sta-
bilizer and remove if present.
9
For Canadian installation and for USA fan and
light kit combinations over 35 lbs, in both flush
and downrod mode the safety cable must be
installed into the house structure beams using
the 3” lag screws provided. Make sure that
when the safety cable is fully extended the
leadwires are longer than the cable and no
stress is placed on the leadwires.
11
Safety cable installation
Safety Cable
Lag Screw
Lag Screw
Safety Cable
Washer
Lock Washer
