7
Remove the reinforced plate
and top housing from motor
assembly. Keep the parts for
later use.
8
I n s e r t b l a d e i n t o t h e s l o t o n
flywheel.
Note:
The ABS blades are curved
by design. Do not attempt to bend
the blades. Distorting the blades
could cause the fan to wobble.
9
I n s t a l l b l a d e w i t h s c r e w s
and fiber washers provided,
aligning each of the holes as
shown and tighten all screws
securely. Repeat this process for
remaining blades.
Note
: Make sure the side with
a label “This side up” is installed
upward.
10
Replace the top housing and
reinforced plate.
11
Re-install the screws removed
in step 6.
16
Re-install the 2 set screws
r e m o v e d i n s t e p 4 a n d
tighten the set screws evenly
once the down rod is in place.
12
14
Place canopy over downrod
Place canopy bottom cap over
downrod and then place yoke
cover over downrod as shown.
Thread lead wires and safety
cable through downrod.
15
Insert downrod into the yoke on top of
fan body. Align the hole in the downrod
with the hole in the yoke. Insert cross
pin through yoke and downrod until
point appears on the other side.
Install Keeper pin.
17
Loosen one and remove one
preassembled screws from
m o u n t i n g b ra c k e t . S a v e
screw for later use.
13
18
Hang assembled fan from the mounting
bracket installed to ceiling in previous
step. Make sure the fan is hanging
straight. Rotate fan until the tab on
the Mounting bracket engages the slot
on the Downrod Ball.
This must be
done to prevent the fan body from
rotating when the blades are in
motion.
Содержание 4VOR60XXD Series
Страница 8: ...Jan 2011...
