Monte Carlo Fan Company 4SBWR56 Series, Руководство пользователя

Страница: 4 / 9

4
7 8 9
© 2021 Monte Carlo Fan Collections
12/2021
10 12 11
Flip the fan body with blades over.
Note
: Carefully handle it and do not
damage or bend the blades with blade
arms.
Partially loosen downrod set screws from
yoke at top of motor assembly.
Remove preassembled keeper pin and
cross pin from downrod. Keep parts
Place downrod over canopy, decorative
cap and yoke cover. Thread lead wires
and safety cable from motor assembly
through downrod.
Note
:
If the fan to be installed on a
slope ceiling, the decorative cap
shouldn’t be installed corresponding
to the installation step 11.
Slip downrod into motor housing yoke,
aligning holes and install cross pin and
keeper pin.
Insert cross pin through yoke and downrod
until point appears on the other side, and
insert keeper pin on cross pin.
Pull the downrod up tight against the
cross pin, and then evenly tighten the
downrod set screws on motor housing
yoke.
Place yoke cover on top housing of fan.
Warning
: Cross pin and keeper pin must
be installed securely, failure to install them
will result in serious injury.
SAFETY CABLE INSTALLATION
Lag screw
Safety cable
Washer
Lock washer
Safety cable must be installed into the
house structure using 3” lag screws,
washers, and lock washers provided,
required for outdoor applications and in
Canada (All fans installed in Canada), and
for USA fan and light kit combinations
over 35lbs.
Make sure that when the safety cable is
fully extended the lead wires are longer
than the cable and no stress is placed on
the lead wires.
Note
: If Installing The Secondary Support
Safety Cable in the U.S., Do Not Remove
Knockouts In The Outlet Box.
Tab
Slot
Blue
Brown
Grey
Install ball end of downrod into mounting
bracket opening. Align (engage) slot on
ball with tab on mounting bracket.
Warning: Failure to align slot on ball with
tab may result in serious injury.
Important : If using the angle mount,
make sure open end of mounting bracket
is installed facing the higher point of the
ceiling and make sure the ceiling angle is
not steeper than 20º. Longer downrod
may be necessary allowing the fan blades
to rotate without obstructions.
Cross pin
Keeper pin
Yoke cover
Downrod
Canopy
Decorative cap
Downrod
Cross pin
Keeper pin
Yoke