Monte Carlo Fan Company 4ICR52**D Series, Руководство пользователя и инструкция по установке

Страница: 5 / 9

7/1/2013 © 2013 Monte Carlo Fan Company
5
19
Lift Conopy allowing the 2 studs to
protrude through the canopy.
Install knurled nuts and tighten the
knurled nuts securely. The canopy
should adjust for any irregularity in
the ceiling or outlet box.
21
L o o s e n 2 a n d r e m o v e 1
preassembled scews from the
plate on motor. Save screw for
later use.
22 23
Attach light pan on to the plate on
motor, aligning the keyhole slots
with the preassembled screws on
the plate. Twist clockwise till lock.
Install the screw removed in step
21. Tighten all screws securely.
L o o s e n 2 a n d r e m o v e 1
preassembled screw from light
pan. Save screw for later use.
24
Connect plug from fan to plug
from light fixture. Make sure the
plugs are hooked together.
25
Spread the plug assembly with wires apart from other components and
Place it in position as shown.
Attach light fixture onto light pan, aligning the keyhole slots on the light
fixture with the screws on light pan and twist clockwise till tight. Install the
screw removed in step 23. Tighten all screws securely.
20
Insert blade into the slot on flywheel and install blade screws, fiber washers
and enhance plate aligning each of the holes as shown. Repeat this process for
remaining blades.
Note: The ABS blades are curved by design. Do not attempt to bend the
blades. Distorting the blades could cause the fan to wobble.
Note : Make sure the side with a label “This side up” is installed upward.
Enhance plate
Hook